LED drive power aging line working video

The configuration of LED drive power aging line drive system

1: 2KW motor, gear box: 100 type tooth box;

2. Speed: 0-2m/min, 2HP frequency converter speed regulation

A total of two sets of the above configuration

LED drive power aging line electrical control configuration

1. The voltage indication adopts digital display type, the system adopts PLC and 7-inch touch screen control, 6 voltage regulators 0-300V., the test instrument fixed point test

2. Use 1 power distribution control cabinet to install, the computer can display, save the basic parameters of the power supply

3. Equipped with an emergency stop switch on the body to facilitate the stop in time when the light is on.

Two sets of LED drive power aging line detection circuit configuration

Set any zone 1 as the cycle life aging control zone. It adopts digital display time relay control, adjustable turn-off time, and voltage change output.

Two sets of LED drive power aging line for full line voltage area configuration

There are a total of 6 voltage regulators in each set, and a total of 6 zones are designed for the line body. The voltage regulator is adjustable from 0 to 300V. The actual power consumption depends on the aging products and quantity at that time.

LED drive power aging line structure configuration

1. The frame adopts 50×50×2mm rectangular steel pipe, the height of the working surface: 1200±20

2. The head and tail guards of the fuselage are made by bending 1.5mm cold steel plate, and the feet are equipped with galvanized adjustable foot cups; the fuselage is 2 meters away, and the cable is sealed around the body. The whole line is high temperature and temperature adjustable.

3. Use C2082HP hollow shaft pin chain produced by Hangzhou Chain Factory